Dynojet WinPEP 7 Manual de usuario descargar pdf (Pagina 82)

WinPEP 7 User Guide

CHAPTER 6

Creating and Editing Gauges (Templates)

6-12

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CREATING AND EDITING GAUGES (TEMPLATES)

The gauges displayed on the MakeRun screen are completely configurable. New

gauges can be added to the screen, and existing gauges can be modified or deleted.

These screens can then be saved as templates and used for future runs.

1 Verify you are in Advanced Mode. Refer to page 2-14 for more information.

2 If you are not already there, go to the MakeRun screen. The last template used is

automatically loaded.

3 Verify you are connected to the dyno electronics. Refer to “Connecting the Dyno

Electronics” on page 3-11 for more information.

4Click the Edit Mode button . You cannot edit gauges unless you are in Edit

Mode.

The gauge toolbar will appear.

5Click the Clear Gauges button to clear all gauges and start with a clean

screen.

All the gauges are removed except the logo. The logo cannot be removed;

however, the logo can be moved around the screen area.

Figure 6-13: Edit Gauges—Edit Mode

edit mode

gauge toolbar

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 169 170

Sin comentarios

Dynojet WinPEP 7 Manual de usuario Pagina 82