Dynojet WinPEP 7 Manual de usuario descargar pdf (Pagina 128)

WinPEP 7 User Guide

APPENDIX D

Analog Channel Configuration

D-6

EDITING A GAUGE

You will need to either create a new gauge or edit an existing gauge to represent your

analog channel. For this example, we will edit an existing gauge.

For more detailed information on creating a gauge, refer to “Creating and Editing

Gauges (Templates)” on page 6-12.

1 Verify you are in Advanced Mode. To change the user level click

Tool s

Environment Options and click on the General tab.

2 If you are not already there, go to the MakeRun screen. Click the Make Run

button . The last template used is automatically loaded.

3Click the Edit Mode button . You cannot edit gauges unless you are in Edit

Mode.

4 Right click on the gauge and choose Gauge Properties.

5 The Gauge Property Editor dialog box will appear.

Each type of gauge has a slightly different dialog box, but most share the same

properties.

6 Select the analog channel you created earlier from the Data Channel drop down

list.

The analog channel selected automatically appears in the Upper Title and on the

gauge.

Note: You must be connected to the dyno electronics and the Analog Module

must be installed for the list of analog channels to be available.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 169 170

Sin comentarios

Dynojet WinPEP 7 Manual de usuario Pagina 128