Dynojet WinPEP 7 Manual de usuario descargar pdf (Pagina 76)

WinPEP 7 User Guide

CHAPTER 6

Run Options

6-6

Load Testing—turn on load testing and configure the parameters for step, sweep, or

custom testing.

• Enable Load Testing—turn on or off load testing. Checking this box is the

same as clicking the Enable Load Testing button .

• Load Test—select the type of load test you wish to perform: step, sweep, or

custom.

Step Testing

• Step Channel—select which channel (speed or engine speed) you would

like to use for step testing.

• Step Size—the size of the step (for example: five m.p.h.).

• Start Value—the start value for the test (for example: 40 m.p.h.).

• Hold—the value the step will hold for (for example: five seconds).

Figure 6-9: Load Testing—Step Test

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 169 170

Sin comentarios

Dynojet WinPEP 7 Manual de usuario Pagina 76