Dynojet Spring Applied Air Release (SAAR) Brake Assembly Manual de usuario descargar pdf (Pagina 20)

Spring Applied Air Release (SAAR) Brake Assembly Installation

SPRING APPLIED AIR RELEASE (SAAR) BRAKE ASSEMBLY INSTALLATION

Installing the SAAR Brake Assembly

INSTALLING THE AIR CAN

1 Thread the pipe fitting which extends from the solenoid subassembly into the

threaded hole on the top of the air can. Apply pipe thread sealer to the fitting if

sealer is not already present.

2 Align the solenoid assembly so that it is parallel to the two bolts that extend from

the bottom of the air can as shown in Figure 17.

Figure 16: Attach the Solenoid Subassembly to the Air Can

3 Remove and set aside the two 5/8" lockwashers and nuts for the air can.

4 Remove and set aside the 5/8" nut from the long threaded rod at the bottom of

the air can.

Figure 17: Prepare the Air Can Assembly

AB093

solenoid assembly

threaded hole

in air can

threaded pipe fitting

air can

align solenoid assembly

with these two studs

BR030

5/8" lockwashers

and nuts

5/8" nut

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

Sin comentarios

Dynojet Spring Applied Air Release (SAAR) Brake Assembly Manual de usuario Pagina 20